Viewing Statistics For Your Client Adapter - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Chapter 7 Performing Diagnostics
Table 7-1
Status
Signal to Noise Ratio
Driver Version
Firmware Version
Message Integrity Check
Current IP Address
Step 2 Tap OK to exit the Status screen.

Viewing Statistics for Your Client Adapter

ACU enables you to view statistics that indicate how data is being received and transmitted by your client
adapter. It also shows message integrity check (MIC) statistics if your client adapter's driver supports
MIC and MIC is enabled on the access point.
The receive and transmit statistics are host statistics. That is, they show packets and errors received
Note
or sent by the Windows CE device. Link status tests from the access point or ACU site survey tool
are performed at the firmware level; therefore, they have no effect on the statistics shown by the
Statistics screen.
OL-1375-04
Client Adapter Status (continued)
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Description
The difference between the signal strength and the current noise
level. The higher the value, the better the client adapter's ability
to communicate with the access point.
Range: 0 to 90 dB
This setting appears only if you selected signal strength to
Note
be displayed in dBm. See the
Display Units" section on page 7-2
The version of the client adapter driver that is installed on your
Windows CE device.
The version of the firmware that is currently running on your
client adapter.
Indicates whether your client adapter is using message integrity
check (MIC) to protect packets sent to and received from the
access point.
MIC prevents bit-flip attacks on encrypted packets. During a
bit-flip attack, an intruder intercepts an encrypted message, alters
it slightly, and retransmits it, and the receiver accepts the
retransmitted message as legitimate.
MIC is supported automatically by the client adapter's
Note
driver, but it must be enabled on the access point.
Value: Yes or No
The IP address of the client adapter. If your Windows CE device
is set up to obtain an IP address from a DHCP server, you can
press the Renew button to initiate a release and renew of the IP
address.
This parameter and the Renew button appear only on PPC
Note
2002, PPC 2003, HPC 2000, and CE .NET devices.
Viewing Statistics for Your Client Adapter
"Setting Signal Strength
for information.
7-5