Enabling Eap-Fast - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Chapter 5 Configuring the Client Adapter
Follow these steps to enable LEAP authentication for this profile.
Step 1 From the Properties screen, select Network Security Type under Property and LEAP from the list of
options in the Value box. When LEAP is enabled, the following parameters on the Properties screen are
changed automatically:
•
•
Step 2 Perform one of the following:
•
•
Tap OK to enable LEAP.
Step 3
Refer to the
Step 4
LEAP.

Enabling EAP-FAST

Before you can enable EAP-FAST authentication, your network devices must meet the following
requirements:
•
•
•
•
OL-1375-04
WEP is set to Dynamic WEP Keys.
Authentication Type is set to Open.
If you want to use a temporary username and password (which must be entered whenever a LEAP
profile is selected, the client adapter is ejected and reinserted, or the Windows CE device is reset in
order to authenticate and gain access to the network), go to
If you want to use a saved username and password (which do not need to be entered whenever a
LEAP profile is selected, the client adapter is ejected and reinserted, or the Windows CE device is
reset because authentication occurs automatically as needed using your saved credentials), enter
your LEAP username, password, and optional domain name in the User Name, User Password, and
User Domain edit boxes.
Usernames are limited to 64 ASCII characters, and passwords are limited to 32 ASCII
Note
characters. However, if a domain name is entered in the User Domain field, the sum of the
username and domain name is limited to 63 ASCII characters.
"Using LEAP or EAP-FAST" section on page 6-2
350 series client adapters must be installed on a PPC 2002, PPC 2003, or Windows CE .NET 4.2
device.
Client adapters must support WEP and use firmware version 5.40.10.
Access points to which your client adapter may attempt to authenticate must use the following
firmware versions or later: 11.23T (340 and 350 series access points), 11.54T (1200 series access
points), or Cisco IOS Release 12.2(4)JA (1100 series access points).
All necessary infrastructure devices such as access points, servers, gateways, and user databases
must be properly configured for EAP-FAST authentication.
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE

Enabling EAP-FAST

Step 3.
for instructions on authenticating using
5-21