Declaration Of Conformity For Rf Exposure - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Appendix C Declarations of Conformity and Regulatory Information
The following CE mark is affixed to the 350 series equipment:
The above CE mark is required as of April 8, 2000 but might change in the future.
This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted
Note
to certain frequencies and/or may require a license for operation. For more details, contact your
customer service representative.
Combinations of power levels and antennas resulting in a radiated power level above 100 mW
Note
equivalent isotropic radiated power (EIRP) are considered as not compliant with the above mentioned
directive and are not allowed for use within the European community and other countries that have
adopted the European R&TTE directive 1999/5/EC or the CEPT recommendation Rec 70.03 or both.
For more details on legal combinations of power levels and antennas, refer to the
Levels and Antenna Gains" section on page

Declaration of Conformity for RF Exposure

The radio module has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) addressing RF Exposure
from radio frequency devices.
OL-1375-04
0650
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE

Declaration of Conformity for RF Exposure

D-3.
"Maximum Power
C-5