Enabling Peap Authentication - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Appendix E Configuring the Client Adapter through Windows CE .NET

Enabling PEAP Authentication

Follow these steps to prepare the client adapter to use PEAP authentication, provided you have
completed the initial configuration.
Check the Enable network access using IEEE 802.1X check box.
Step 1
Step 2 Select Cisco PEAP in the EAP type drop-down box.
Note
Step 3 Tap the Properties button. The PEAP Properties screen appears (see
Figure E-4
Make sure the Validate server certificate check box is checked if server certificate validation is required
Step 4
(recommended).
Check the Connect only if server name ends in check box and enter the appropriate server name suffix
Step 5
in the text box below.
Note
OL-1375-04
If the Microsoft PEAP supplicant is installed (rather than the Cisco PEAP supplicant), PEAP
(rather than Cisco PEAP) appears in the EAP type drop-down box. Follow the instructions in
your Microsoft documentation to configure your client adapter to use Microsoft PEAP.
PEAP Properties Screen
If you leave this field blank, you are prompted to accept a connection to the server to which your
client adapter is connected during the authentication process.
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Configuring the Client Adapter
Figure E-4).
E-9