HP 166207-B21 - Smart Array 5302/32 RAID Controller Reference Manual page 89

Error Error message
code
2843 Invalid Size
2844 Invalid Stripe Size
2849 Invalid ClearConfigurationWithDataLoss
parameter
2850 Controller does not support Chassis
Name
2851 Invalid Chassis Name
2852 Invalid SSP State
2853 Cannot change SSP settings
2854 Invalid SSP Adapter ID
2857 Invalid Surface Scan Delay
2861 Controller does not support redundancy
settings
2864 Invalid Preferred Path Mode
2865 Invalid Preferred Path
2866 Failure opening capture file <text>
2867 Failure opening input file <text>
2868 Failure opening error file <text>
2877 There are no suitable spares available
2880 Invalid Physical Disk Type Specified
2882 Invalid MNP delay
3000 Invalid Option
3002 Command Failed
3003 License Key Delete Failed
3004 Invalid Sector Size
3005 Cannot delete Array
Comment or clarification
The specified size is invalid or is not possible with
the current configuration.
The specified stripe size is invalid, not supported
by the current RAID level, or not possible with the
current configuration.
The valid parameters are Yes and No (default).
The controller does not support setting a chassis
name.
The entered chassis name is invalid. Use
characters from the set a–z, A–Z, 0–9, !, @, #, *,
(, ), ,, -, _, +, :, ., /, and [space]. The name
cannot end with a space character or exceed the
maximum number of characters allowed by the
controller.
The requested SSP state is not a valid SSP state.
The SSP settings cannot be changed for the
controller or logical drive.
The adapter ID is not a valid adapter ID that was
detected by the controller.
—
The controller is not redundant or does not
support redundancy settings.
The specified value for the preferred path mode is
not valid, or the controller is not available.
The specified preferred path is not a valid chassis
slot for an available, active controller, or the
controller is not available.
—
—
—
ACU found no drives that could be used as spares
for the specified array.
—
The specified value for MNP delay is invalid.
The value of the option supplied to this parameter
is invalid.
The controller returned an error for a command.
ACU is unable to delete the license key.
—
—
HP Array Configuration Utility 89