Table of Contents
Advertisement
controller all
controller slot=2 array all
controller slot=3 physicaldrive 1:2-1:5
The <command> variable
The <command> variable can be any of the following words or phrases, corresponding to typical
configuration tasks:
add
create
delete
modify
remove
set target
There are also four nonconfiguration commands:
diag
("Generating a diagnostic
help
("The help
rescan
("The show
show
A command often requires a parameter, and some parameters require a value, but the specific
parameters and values that are valid for a given command depend on the target to which you apply the
command.
To determine the valid parameters and values for a particular combination of target and command
variables, you can query the device
example commands in other sections of this guide.
Querying a device
If you do not know what values a parameter can have, you can sometimes query the device to find out by
entering a ? as the value of the parameter.
Example command:
=> ctrl ch="Lab4" ld 1 modify raid=0 ss=?
A typical screen response in this case could be:
Available options are:
8
16 (current value)
32
64
128 (default)
256
To determine which parameters can be queried, use the help feature of the CLI
page 59).
Hiding warning prompts
When you enter a command for an operation that can potentially destroy user data, the CLI displays a
warning and prompts you for input (a y or an n) before continuing the operation. This situation is
command" on page 59)
("Rescanning the
system" on page 61)
command" on page 57)
("Querying a
report" on page 61)
device" on page 56). You can also inspect the
("The help
command" on
HP Array Configuration Utility 56
Hide quick links:
Advertisement
Table of Contents
