Restoring A Configuration; Configuration Download Without Disabling A Switch; Cli Commands To Display Or Modifiy Switch Configuration Information - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Restoring a configuration

Restoring a configuration involves overwriting the configuration on the switch by downloading a previously
saved backup configuration file. Make sure that the configuration file you are downloading is compatible
with your switch model, because configuration files from other model switches might cause your switch to
fail.
The configuration download process is additive, that is, the lines read from the files are added to the
current switch configuration. You can change a single configuration variable by downloading a file with
that specific variable only. When you do so, all other variables remain unchanged.
If a configupload command is issued on a non-FCR platform, such as the configuration file from an 400
MP Router, FCR-like parameters may be viewed in the uploaded data. This is harmless to the switch and
can be ignored.
Run the commands listed in
emergency reference.
Table 44

CLI commands to display or modifiy switch configuration information

Command
configShow
fcLunQuery
fcrRouterPortCost
fcrXlateConfig
fosConfig
ipAddrShow
iscsiCfg
iscsiPortCfg
iscsiTargetName
isnscCfg
licenseShow
portCfgEXPort
portCfgVEXPort
The configuration download process is additive, that is, the lines read from the files are added to the
current switch configuration. You can change a single configuration variable by downloading a file with
that specific variable only. When you do so, all other variables remain unchanged.
NOTE: The switch has no error checking and edited files may become corrupted and can lead to switch
failures.

Configuration download without disabling a switch

You can download configuration files to a switch while the switch is enabled, that is, you do not need to
disable the switch for changes in SNMP, Fabric Watch, and ACL parameters. When you use the
configDownload command, you will be prompted to disable the switch only when necessary. However,
if there is any changed parameter that does not belong to SNMP, Fabric Watch, or ACL, then you must
disable the switch.
Configuration download without disabling a switch is independent of the hardware platform and
supported on all hardware platforms running Fabric OS 5.2.0 and later.
Table 44 and save the output in a file format. Store the files in a safe place for
Displays
System configuration parameters and settings, and license information.
A list of LUN IDs and LUNs for all accessible targets.
FC Router route information
A translate (xlate) domain's domain ID for both EX_Port-attached fabric and
backbone fabric.
Fabric OS features.
The IP address.
iSCSI entities.
The iSCSI port parameters.
The IQN prefix.
The configuration state of the iSNS client operation.
The license keys you have installed and provides better detail than the license
information from the configShow command.
EX_Port configuration parameters.
VEX_Port configuration parameters.
Fabric OS 6.1.x administrator guide 145