Table of Contents
Advertisement
Copying a program
When similar parts will be measured, it is often quicker to copy an
existing program and edit it to accommodate the new part than to
record a new program from the beginning.
To copy a program:
U
Press the MENU soft key to display the menu soft key titles at the
bottom of the screen.
U
Press the PROG soft key to display the Programs screen.
U
Highlight the desired program number using the ARROW CURSOR
keys.
U
Press the COPY soft key.
U
Enter the new program number and press the OK soft key.
The new copy of the original program can now be edited to
accommodate the new part measurement requirements.
The insertion point is highlighted
ND 1200 QUADRA-CHEK
The COPY soft key is pressed and the
new program number is entered
The new copy of the original program is
shown in the program list
69
Advertisement
Table of Contents
