Remote Arming/Disarming Via Dtmf; Lcd Keypad Alarm Activation - Marmitek PROGUARD 800 Installation Manual

F u
1
While the SMS Command Descriptor is optional, you must start the SMS command with
the # symbol for the system to accept the command.
After an SMS command is executed by the system, you can program the system to
return a confirmation message to the sender – see 10.7.5: SMS Confirmation.
3.8.1: Arm Status Reply
On receiving an Arm Status request message, the system returns a status message to
the sender. This message includes the system status and the descriptor of the user or
the device used to arm/disarm the system.
The following example shows an Arm Status reply where the system has been fully
armed by a user named Mark.
F

3.9: Remote Arming/Disarming via DTMF

Using the Telecontrol feature, you can fully arm and disarm the system via the telephone
with DTMF commands. For further information on the Telecontrol features, see Chapter
Five: Telecontrol and 5.1.5: Arm/Disarm DTMF Commands.

3.10: LCD Keypad Alarm Activation

In the event of an emergency, the user can generate three kinds of alarm from the front panel
keypad and the HK855 Hardwire LCD Keypads.
To activate an SOS alarm from the front panel keypad:
x
Press both Home Automation keys simultaneously.
To activate an SOS alarm from the HK855 Hardwire LCD Keypad:
x Press 2 and 3 simultaneously.
To activate a Fire alarm from the front panel or HK855 Hardwire LCD Keypad:
x
Press keys 1 and 3 simultaneously.
-26-
X
L l A
U L L A
Figure 3.6: SOS Alarm Activation (front panel keypad)
Figure 3.7: SOS Alarm Activation (HK855 Hardwire LCD Keypad)
Y Z
r m # 1 2
R M E D
[
3 4 1 2
- M A R K
1
© MARMITEK