Installation Procedure - Marmitek PROGUARD 800 Installation Manual

x
The reduction of the RF signals' strength is directly proportional to the
thickness of the obstacle, assuming that the obstacles are of identical
material.

2.2: Installation Procedure

After unpacking the kit and making certain that you have all the necessary equipment, it
is recommended that you install the system as follows:
STEP 1: Open the housing.
STEP 2: Temporarily power up the system.
STEP 3: Register the transmitters.
STEP 4: Test the chosen mounting location.
STEP 5: Permanently install the control panel and transmitters.
2.2.1: Step 1 – Opening the Housing
To open the housing:
1. Remove the housing screw located
at the bottom of the front cover.
2. Using a screwdriver carefully
press the release tabs as shown
in Figure 2.4.
3. Lift the front cover away from the
back of the housing. You will
notice that the front cover is
attached
two fastening bands and the
keypad's flat cable.
2.2.2: Step 2 – Powering Up the System
In order to register and test transmitters, it is necessary to temporarily power up the system
before installing the control panel. At this stage, do not connect the backup battery.
Thread the power cable through the wiring hole on the back cover and connect the cable to
the AC power input on the Main board. For the exact location of the AC power input, see
section 1.4.1: The Main Board. Close the front cover and apply AC power. At this stage,
ignore any trouble conditions that may appear on the LCD display (e.g. Low Battery).
-14-
Figure 2.3: Considering Thickness of Obstacles
to the back with
Figure 2.4: Opening the Housing
Housing
Screw
© MARMITEK