Marmitek PROGUARD 800 Installation Manual page 16

3. Enter 709 (Service, GSM Signal); the signal strength of the cellular
network is displayed – see 4.7.9: GSM Signal Strength for further
information.
2.2.5: Step 5 – Installing the Control Panel and Transmitters
Having chosen and tested the mounting location of the control panel and each
transmitter, you are now ready to permanently install the system.
To permanently install the transmitters, refer to each device's installation instructions (in
Appendix B of this manual or supplied individually with each product).
To install the control panel:
1. Disconnect AC power from the control panel.
2. Open the housing as explained in section 2.2.1: Step 1 – Opening the
Housing.
3. Remove the backup battery pack. If you want to install the control
panel with back tamper, it is also necessary to disconnect the flat cable
connecting the Main board to the front panel keypad and remove the
Main board. Figure 2.5 shows the control panel with the Main board
and the battery pack removed.
Upper
Mounting
Hole
Location of
Back Tamper
Screw
Lower
Mounting
Hole
4. Place the control panel in position against the wall and mark the upper
and lower mounting holes. If using the back tamper, also mark the hole
for the back tamper screw.
5. Install wall anchors in the appropriate positions.
6. Thread any required cables through the wiring hole on the back cover
(e.g. AC power and telephone line) and make any necessary wiring
connections.
7. Connect the power cable to the AC power input on the Main board –
see 1.4.1: The Main Board.
8. Connect the telephone line to the Telephone Line terminal block on the PSTN
module – see 1.4.2: PSTN Module.
9. Connect any additional HK855 Hardwire LCD Keypads if required – see 2.4:
Installing HK855 Hardwire LCD Keypads.
-16-
Figure 2.5: Back Cover (Main Board and Battery Pack removed)
Upper
Mounting
Hole
Lower
Mounting
Hole
© MARMITEK