Marmitek PROGUARD 800 Installation Manual page 15

Hide thumbs Also See for PROGUARD 800:
Table of Contents

Advertisement

2.2.3: Step 3 – Registering Transmitters
For the control panel to recognize a device, its transmitter must be registered. In general
terms, transmitter registration means sending two transmissions from a device when the
control panel is in "Registration" mode.
To register a device:
Press 3.
1.
2.
Enter your Installer code (the default Installer code is 1111).
3.
Enter 91 (Programming, Devices) to enter the Devices menu.
4.
Press the menu navigation keys (/), until the type of device you
want to register appears on the LCD display (e.g. Zones or Keypads).
Press 3.
5.
6.
Press the menu navigation keys (/), until the exact device you
want to register appears on the LCD display (e.g. Zone 3 or Keypad 2).
Press 3. If a device has not been registered at the chosen location,
7.
the control panel initiates Registration mode. During Registration
mode, the system waits for two transmissions from the device.
1
If a device has already been registered at the required location, the system will not initiate
Registration mode. If the device has already been registered at another location, attempts
to register are ignored by the system.
8.
Send two transmissions from the device – refer to each device's
installation instructions in Appendix B for further details.
When Save? is displayed on the control panel's LCD, press 3. The
9.
display automatically switches to the next option for that device. For
example, pressing 3 to confirm Zone registration automatically moves
you to the Zone Type option.
10.
Continue entering other parameters for the chosen device.
1
Pressing 2 returns you to the previous menu level. Press 2when you are in the Main menu
(Menu Level 1) to exit menu mode.
2.2.4: Step 4 – Testing the Chosen Mounting Location
Once all of the transmitters are registered, it is recommended that you test the chosen
mounting locations before permanently mounting the control panel and wireless devices. You
can test the transmitter signal strength using the TX Test feature.
To test transmitter signal strength.
Press 3.
1.
2.
Enter your Installer code.
3.
Enter 7072 (Service, Transmitters, TX Test) to initiate TX Test mode.
4.
Activate the transmitter you wish to test; the transmitter's details appear
on the control panel's LCD. Additionally, between one and four tones are
sounded to indicate the transmitter's signal strength. If four tones are
sounded, the transmitter is in the best possible location – see 4.7.7:
Transmitters for further information.
After you have tested each transmitter, press 2 to exit TX Test mode.
5.
If installing with the GSM Cellular Communications module, test the GSM signal strength
using the system's RSSI meter.
To test the GSM signal strength:
Press 3.
1.
2.
Enter your Installer code.
ProGuard800™
-15-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proguard 800 series

Table of Contents