Table of Contents
Advertisement
Smoke Detector (SD833)
The SD833 is a brand-name smoke detector with an integrated Marmitek transmitter.
Installation Procedure
The following procedure explains the installation of the SD833 wireless smoke detector
and its registration to the receiver. For further information regarding the smoke detector's
location, test procedures, maintenance and specifications, refer to the manufacturer's
installation instructions provided with this product.
To install smoke detectors:
1.
Open the cover by lifting the opening
tab while firmly holding the base with
your other hand.
2.
Push
the
separate the cover from the base.
3.
Install a 9V battery into the detector's
battery snap.
4.
Insert the Test jumper; the SD833
enters Test mode and the LED
flashes every few seconds.
5.
From the Programming menu, select
Devices, Zones [911].
6.
Select the zone to which you want to
register the transmitter; the system
initiates Registration mode. When
Save? appears on the panel's LCD
display, press 3.
7.
After registration, remove the Test
jumper and place it over one pin for
storage.
8.
Before permanently mounting the unit, test the transmitter from the
exact mounting position.
9.
Attach the mounting base to the ceiling using the screws provided.
10.
Replace the cover onto its hinges and close the cover until it snaps
together with the base.
-102-
cover
backwards
Opening
Tab
to
LED
Indicator
Test
Jumper
9V
Battery
Figure B.9: SD833 (cover open)
© MARMITEK
- Quick Links:
- Chapter Two: System Installation
Hide quick links:
Advertisement
Table of Contents
