Table of Contents
Advertisement
To install HK855 Hardwire LCD Keypads.
1.
Disconnect all power, both AC and battery, from the control panel.
2.
Remove the back cover of the keypad. To do so, press the two snaps
(located at the bottom of the keypad) using a small flat-head
screwdriver and carefully pull the back cover away from the front of the
housing.
3.
Place the back cover of the keypad in position against the wall and
mark the upper and lower mounting holes.
4.
Install wall anchors in the appropriate positions.
5.
Thread the cable from the control panel through the wiring hole on the
back cover and attach the back cover to the wall using four screws.
6.
Connect the terminal block on the keypad to the appropriate terminal
block on the control panel's main board as shown in Figure 2.8.
7.
Reapply power to the control panel.
8.
Set the keypad address as follows:
a.
b.
c.
d.
9.
Position the front cover's top holding hooks onto the back cover and
snap the front cover closed.
10.
After installing hardwire keypads, perform the Find Modules function – see
12.5: Find Modules.
-18-
Figure 2.8: Connections for HK855 Hardwire LCD Keypad
Make certain the keypad's tamper switch is open.
On
the
keypad,
simultaneously.
Use the arrow keys (/) to select the keypad
address.
Press 3.
press
keys
1,
3
and
5
© MARMITEK
- Quick Links:
- Chapter Two: System Installation
Hide quick links:
Advertisement
Table of Contents
