Marmitek PROGUARD 800 Installation Manual page 33

4.7.2: Message Center
The ProGuard800 Message Center is designed to allow the user to record a short
message that may be played back later by another user. After a message is recorded,
Message Waiting is displayed on the LCD until the message is played back.
To play back a recorded message:
x
From the Service menu, select Messages, Play Message [7021].
To record a message:
1. From the Service menu, select Messages, Record Message [7022].
Press 3 to start recording the message.
2.
3. Record your message. The message may be up to twenty seconds
long.
Press 3 to stop recording; the message is automatically played back
4.
and OK? is displayed.
Press 3 to save your recording.
5.
To delete a message:
1. From the Service menu, select Messages, Delete Message [7023];
OK? is displayed.
Press 3; the message is deleted.
2.
1
The Record and Play options can also be accessed via a convenient shortcut without
needing to enter a valid user code.
To access the Record Message option from Standby mode, press  then
To access the Play Message option from Standby mode, press  then
4.7.3: Wireless Siren Test
To test the wireless siren:
x
From the Service menu, select WL Siren Test [703]; the external siren
is sounded briefly.
4.7.4: Siren Test
To test the control panel's built-in siren:
x
From the Service menu, select Siren Test [704]; the control panel's
built-in siren is sounded briefly.
4.7.5: Interface Test
The Interface test enables you to check if the speaker, LEDs and LCD are functioning
correctly.
To test the system interface:
x
From the Service menu, select Interface Test [705]; a short sequence
of chimes are sounded from the speaker, all LEDs flash and the LCD is
tested on all connected LCD keypads.
ProGuard800™
2
.
3
.
-33-