Camera Installation; Pan/Tilt Dome Camera Operation; Camera Part - Marmitek 14” COLOR OBSERVATION SYSTEM Owner's Manual

PAN/TILT DOME CAMERA OPERATION

CAMERA PART

Electrical power is not connected to the dome and observation / quad monitor during installation.
FRONT VIEW
CAMERA IN STALLATION
Be sure that no power is connected to dome camera and observation / quad monitor during installation.
1. Twist open the clear dome cover to CCW to reach inside the dome camera.
2. Place the controller on the desk or proper appropriate location.
3. Connect the controller and the observation / quad monitor with 10ft din cable.
(Included in the package of controller)
4. Wiring the 60ft din cable from controller to dome camera.
5. Attach the adaptor plate on the ceiling. Using Ø3 X 20 screws (included)
6. Twist the base of the dome camera to the adaptor plate on the ceiling.
Do not hold clear bubble or swivel, when you attach the dome to adaptor plate.
7. Attach one end of DIN connector to the back of the control unit's connector. (named camera)
Repeat sequence 1 through 7 until install all dome cameras.
or
TOP VIEW
A
105
Adaptor plate
Ø3 x 20 screw
Hook
Base (hold base when you
twist to attach the
dome to adaptor plate)
Swivel
Bubble
10