C Connectors At J1 And J2 (Not Installed) Pin-Out; Front Panel Controls And Indicators; Table 43. Front Panel J1 And J2 I - Intel SC5300BRP Technical Product Specification

Intel® Server Chassis SC5300 5U Kit TPS
Pin #
Pin 33 ID_TOGGLE GND
When the hot swap drive bay is installed, a bi-color hard drive LED is located on each drive
carrier (five total) to indicate specific drive failure or activity. For pedestal systems, these LEDs
are visible upon opening the front bezel door.
2
6.1.3 I

C Connectors at J1 and J2 (Not Installed) Pin-out

6.1.4

Front Panel Controls and Indicators

The front panel control buttons and LED indicators are displayed in the following figure. The
tool-activated non-maskable Interrupt (NMI) switch is located below the Status Fault LED. When
the hot swap drive bay is installed, a bi-color hard drive LED is located on each drive carrier (six
total) to indicate specific drive failure or activity. For pedestal systems, these LEDs are visible
upon opening the front bezel door.
Revision 1.31
Description

Table 43. Front Panel J1 and J2 I

Pin 1
Pin 2
Pin 3
Pin 4
Pin #
Pin 34 HDD_FAULT L
2
C Pin-out
SDA
GND
SDL
NC
Front Panel
Description
75