Configuring Tftp Options; Assigning A Tftp Sever - Cisco 7912G - IP Phone VoIP Administration Manual

Configuring TFTP Options

Configuring TFTP Options

Assigning a TFTP Sever

Using the Phone Configuration Web Page (Cisco IP Phone Models 7902G/7905G/7912G)
Step 1
Step 2
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
4-28
If you do not use DHCP to direct the Cisco IP Phone to a TFTP server, you must
manually assign one. You can also assign an alternative TFTP server to use
instead of the one assigned by DHCP. On the Cisco IP Phone 7902G, you can
manually enable or disable TFTP.
This section covers these topics:
Assigning a TFTP Sever, page 4-28
•
Enabling an Alternate TFTP Server, page 4-30
•
If you are not using DHCP in your network, and you want to change this setting,
you must manually assign the TFTP server to the phone.
Before you can manually assign a TFTP server, you must enable an alternate
TFTP server. For instructions, see the
section on page 4-30.
Procedure
Open the Phone Configuration web page.
Open your web browser and enter the following URL, where IPaddress is the
a.
IP address of your phone
http://IPaddress
b. Press Enter.
The Phone Configuration web page appears.
In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
Chapter 4 Configuring Network Settings on the Cisco IP Phone
"Enabling an Alternate TFTP Server"
OL-6313-01