Understanding the Requirements for Installing and Configuring the Cisco IP Phone Models 7902G/7905G/7912G
Understanding the Requirements for Installing and
Configuring the Cisco IP Phone Models
7902G/7905G/7912G
Note
Table 1-2
Overview of Configuration Procedures for the Cisco IP Phone
Required Task
1.
If the Cisco IP Phone model that
you want to configure does not
appear in the Phone Type
drop-down list in
Cisco CallManager, go to the
following URL and install the
latest support patch for your
version of Cisco CallManager:
http://www.cisco.com/cgi-bin/
tablebuild.pl/callmgr-33
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
1-12
Related Topic
Providing Information to Users Via a Web Site, page 5-9
•
To install and configure the Cisco IP Phone models 7902G/7905G/7912G, you
must configure some network settings, set up Cisco CallManager, and make
changes locally on the phone.
Refer to
Table 1-2
for an overview of required procedures. For detailed
information about these steps, refer to the sources shown.
You can specify additional configuration settings using profile files stored on the
TFTP server. For more information, see
Methods, Parameters, and Procedures."
Purpose
The support patch allows
Cisco CallManager to identify
a Cisco IP Phone.
Chapter 1
An Overview of the Cisco IP Phone
Appendix A, "Additional Configuration
For More Information
Refer to instructions on the
same web page as the
support patch.
OL-6313-01