Changing The Logo On The Cisco Ip Phone Lcd Screen - Cisco 7912G - IP Phone VoIP Administration Manual

Appendix A Additional Configuration Methods, Parameters, and Procedures
Step 3
Step 4
Step 5
Step 6

Changing the Logo on the Cisco IP Phone LCD Screen

Note
Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
OL-6313-01
• Press 20 # to configure DHCP
Press # to go to the extended menu
•
Enter the voice menu code for the setting that you want to verify or change, and
then press #.
Use the * key to toggle between alphanumeric and numeric input mode.
Note
For example, when you enter 905 #, the IVR prompts you for
alphanumeric input. When you enter 905 * #, the IVR prompts you for
numeric data.
Follow the prompts and enter the appropriate values.
The IVR repeats the value you entered, then prompts you to press one of the
following keys:
1=Change your entered value
•
2=Review your entered value
•
• 3=Save your entered value
4=Review the current saved value
•
Hang up the phone. The phone resets.
This section does not apply to the Cisco IP Phone 7902G.
When the Cisco IP Phone models 7905G and 7912G are not in use for a call, a
graphic appears on the LCD screen. Using TFTP configuring, you can change this
graphic to one that you provide. For example, you might change the graphic to
your company logo.
Changing the Logo on the Cisco IP Phone LCD Screen
A-27