Page 41
settings on the camera.
Advanced user – Can view and configure the camera excluding the "User Access"
B.
section.
Normal User – Can only view the live image and cannot configure.
C.
At this stage, you can also bind a MAC address for the user. This means that this user will
only be able to connect from a single pre-defined device and his access will be denied if he
will try to connect from any other device.
Click on "OK" and "Save"
Modify user:
Select the user you wish to modify and click on the
"Modify" button. A modification window will pop up as
shown below.
You can change the username if required. If you wish to
edit the password of the user, tick "modify password"
and input the old password, new password, and
confirmation of the new password.
You can also bind a MAC address for the user as
explained in the "Add user" section.
Click "OK" to save.
Delete user:
Select the user you wish to delete and click on the "Delete" button. A confirmation prompt
will pop up. Click "Ok" to confirm.
Note: The default user "admin" cannot be deleted.
4.1.2 Online Users
"Online users" section will allow you to view users who are currently connected to the camera.
Administrator level users can also kick out other users who are currently connected to the
camera.
Go to "Network" →"Online Users" to access the following interface.
You can view the IP address, port, username and user type used for the connection.
The "Kick Out" button will kick out the selected user and input his IP address to the blacklist.
Click on it for the relevant user and confirm the prompt message.
IP CAMERA USER MANUAL
Need help?
Do you have a question about the IP Series and is the answer not in the manual?