Page 32
IP CAMERA USER MANUAL
Press the "Save" button to save the settings.
The next tab is "IP Change Notification Config": If you have used DHCP and you need to be
notified that the IP Address assigned to the camera was changed, enable it and set Email or
FTP for the notification process.
4.5.2 Port
1. Go to "Network"
"Port" to see the interface as shown below.
→
2. Input port number for IE access in the "HTTP Port" textbox.
3. Input the port number for audio & video transmission in the "Data Port" textbox.
4. Set the RTSP port for video/audio transmission over RTSP
5. Set the HTTPS port in case that you wish to use Secured HTTP connection.
6. Set the Long Polling Port when there is a usage of the LPR analytics by any external
software / app.
4.5.3 Server Configuration
Go to "Network"→ "Server".
This section refers to "Auto Report
Server". Enable it if required.
Auto report server will make the camera
to report back to the defined server using
the port 2009.
Set the port (default port is 2009. It is
advisable not to change it.) Set the server
address (usually it is the CMS address
which needs to be a static address). Set a unique device ID. Each of the devices using auto
server report should have its own ID.
The Camera will report back to the defined server its current IP using port 2009.
4.5.4 DDNS Configuration
1. Enter into "Network"→"DDNS" tab as below:
Need help?
Do you have a question about the IP Series and is the answer not in the manual?