Provision ISR IP Series User Manual page 27

Page 22
IP CAMERA USER MANUAL
After enabling the alarm, choose the responses required from the camera in case the alarm
will be active. After the setting is complete, click "Save".
Next is the "IP Address Collision". This alarm will be triggered when another device in the
network will be assigned with the same IP address of the IPC (or vice versa).
To activate it, enable the alarm.
After enabling the alarm, choose the responses required from the camera in case the alarm
will be active. Note that any response related to the network such as email or FTP is not
available since in most cases the network will become unavailable for the camera. After the
setting is complete, click "Save".
Last is the "Cable Disconnected" tab. This alarm will be generated if the network cable will
be disconnected from the camera. Please note that this alarm is not usable if you are using
PoE to power the camera since the disconnection of the cable will cause the camera to turn off
due to power loss.