Loading Media In Peel-Off Mode (Option) - Wasp WPL608 User Manual

2.6.3 Loading Media in Peel-off Mode (Option)

1. Lift open printer right side cover.
2. Push the print head release lever to open the print head mechanism.
3. Move the label roll guard horizontally to the end of label spindle then flip down the label roll guard.
4. Place the roll of media on the label supply spindle. Flip up the label roll guard. Move the label roll
guard horizontally to fit the width of label roll.
5. Pull label roll leading edge forward through the media guide bar, damper media sensor and place the
label leading edge onto the platen roller.
6. Adjust the label guide to fit the width of the label.
7. Using the front display panel, set the media sensor type and calibrate the selected sensor. (Please
refer to section 3.1.2)
8. Then, pull approximately 25"/650mm of label through the front of the printer.
9. Push down the peel-off roller release lever.
Peel-off roller
release lever
10. Feed the label between peel-off roller and platen roller.
11. Wrap the label onto the internal rewind spindle and wind the spindle counter-clockwise about 3~5
rotations until the label is properly stretched.
Peel-off roller
18