Wasp WPL608 User Manual page 61

The left side printout
position is incorrect
Missing printing on
the left or right side of
label
RTC time is incorrect
when reboot the
printer
Multi interface board
doesn't work
Power and Error LEDs
are blinking fast
Wrinkle Problem
Gray line on the blank
label
Irregular printing
* Wrong label size setup.
* The parameter Shift X in LCD menu is
incorrect.
* Wrong label size setup.
* The battery has run down.
* The installation is incorrect.
* Power switch OFF and ON too fast.
* Printhead pressure is incorrect.
* Ribbon installation is incorrect.
* Media installation is incorrect.
* Print density is incorrect.
* Media feeding is incorrect.
* The printhaed is dirty.
* The platen roller is dirty.
* The printer is in Hex Dump mode.
* The RS-232 setting is incorrect.
* Set the correct label size.
* Press [MENU]
[SELECT] to fine tune the parameter of Shift
X.
* Set the correct label size.
* Check if there is a battery on the main board.
* Check if the board is plugged in the right
connector.
* Turn off the printer and wait all LEDs are dark,
and turn on the printer again.
* Please refer to the 5.2 chapter.
* Please set the suitable density to have good
print quality.
* Make sure the label guide touch the edge of the
media guide.
* Clean the printhead.
* Clean the platen roller.
* Turn off and on the printer to skip the dump
mode.
* Re-set the Rs-232 setting.
58
[SELECT] x 3 [DOWN] x 5