Wasp WPL608 User Manual page 38

A. Gap Mode
Calibration
> Gap Mode
Bline Mode
Cont. Mode
Press the and
button to enter the sensor calibration mode.
Note: If printing from enclosed software/driver, the software/driver will send out the GAP or
BLINE command, which will overwrite the sensor type setting set from the front panel.
A-1 Automatic
When you select the [Automatic] option, you will see the following message, and the printer
will feed 2 to 3 gap labels to automatically calibrate the sensor sensitivity. When calibration
is completed, the LCD screen will return to the previous menu.
Gap Mode
Automatic
A-2 Manual
In case "Automatic" sensor calibration cannot apply to the media, please use the "Manual"
function to calibrate the gap sensor manually.
Gap Mode
Automatic
> Manual
Pre-Printed
When you select the [Manual] option, you will see the message below. Please complete
these steps：
1/4
Gap Mode
> Automatic
Manual
Pre-Printed
buttons to scroll the cursor to the media type and press the
2/4
Paper Len.
00812 dot
Gap Size
0024 dot
1/4
1. Press the
the cursor from left digit to right digit,
and press the
the value from "0" to "9" and the "dot/
mm/ inch". Press the
button to set the paper length into the
printer.
2. Press the
the cursor from left digit to right digit,
and press the
the value from "0" to "9" and the "dot/
mm/ inch". Press the
button to set the gap size into the
printer.
35
button to move
button to set
button to move
button to set