Wasp WPL608 User Manual page 32

3.1.1.1 Speed:
Print Setup
> Speed
Density
Direction
Use this option to setup print speed. The available print speed is between 4~12 ips and each
increament/decreament is 1 ips. The default print speed is 6 ips.
Press the
speed. Press the
setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the SPEED
command, which will overwrite the setting selected on the front panel.
3.1.1.2 Density:
Print Setup
Speed
> Density
Direction
Use this option to setup printing darkness. The available setting is from 0 to 15, and the step is 1.
Printer default density is 8.You may need to adjust your density based on selected media.
Press and
key to enable the setting. Press the
previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
DENSITY command, which will overwrite the setting selected on the front panel.
3.1.1.3 Direction:
Print Setup
Speed
Density
> Direction
The direction setting value is either 1 or 0. Use this option to setup the printout direction. Printer
default printout direction is DIRECTION 0.
Press the
key to enable the setting. Press the
previous menu.
The following 2 figures are the printouts of DIRECTION 0 and 1 for your reference.
1/12
key to raise the print speed, and press the
key to set it into printer. Press the
2/12
to increase/decrease the printing darkness. Press the
3/12
key to set the direction as 1, and
Speed
6
Density
8
key to cancel the setting and return to the
Direction
0
key to cancel the setting and return to the
29
key to decrease print
key to cancel the
to set it as 0, and the