Wasp WPL608 User Manual page 33

DIRECTION 0
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting selection made on the front panel.
3.1.1.4 Print Mode: (None/Batch Mode/Peeler Mode/Cutter Mode/Cutter Batch)
Print Setup
Density
Direction
> Print Mode
This option is used to set the print mode. Printer default setting is Batch Mode. When enter this list,
the print mode in the right side of " >" icon is the printer current setting. Press
to select the different print mode and press the
Press the
Printer Mode
None
Batch Mode
Peeler Mode
Cutter Mode
Cutter Batch
Note: If printing from enclosed software/driver, the software/driver will send out the
4/12
Print Mode
> Batch Mode
Peeler Mode
Cutter Mode
key to cancel the setting and return to the previous menu.
Next label top of form is aligned to the print head burn line location.
(Tear Off Mode)
Once image is printed completely, label gap/black mark will be fed to
the tear plate location for tear away.
Enable the label peel off mode.
Enable the label cutter mode.
Cut the label once at the end of the printing job.
30
DIRECTION 1
2/6
button to enable the setting.
Description
and