Print Mode - Wasp WPL608 User Manual

command, which will overwrite the setting set from the front panel.
3.1.1.5 Offset:
Print Setup
Direction

Print Mode

> Offset
This option is used to fine tune media stop location. Press the
from left digit to right digit, and press the
Press the
setting and return to the previous menu. The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
OFFSET command, which will overwrite the setting set from the front panel.
3.1.1.6 Shift X & Shift Y:
Print Setup
Offset
Shift X
> Shift Y
This option is used to fine tune print position. Press the
left digit to right digit, and press the
the button to set the value into printer. Press
return to the previous menu. The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the SHIFT
command, which will overwrite the setting set from the front panel.
3.1.1.6 Reference X & Reference Y:
Print Setup
Shift Y
Reference X
> Reference Y
This option is used to set the origin of printer coordinate system horizontally and vertically. Press the
button to move the cursor from left digit to right digit, and press the
the value from "0" to "9". Press the
key to cancel the setting and return to the previous menu. The default value is 000.
Note: If printing from enclosed software/driver, the software/driver will send out the
5/12
Offset
button to set the value into printer. Press
7/12
Shift Y
9/12
Reference Y
31
+000
button to set the value from "+" to "-" or "0" to "9".
+000
button to set the value from "+" to "-" or "0" to "9". Press
000
button to set the value into printer. Press
button to move the cursor
key to cancel the
button to move the cursor from
key to cancel the setting and
button to set