Wasp WPL608 User Manual page 42

Bline Mode
Scan Mark
Intensity
Ref. Level
Bline Mode
Scan Paper
Intensity
Ref. Level
Note:
Normally, the value of "Ref. Level" for mark should be larger than paper
for over 128. If the media sensor fails to do so, you have to manually
change the Intensity by pressing
above value.
Bline Mode
Complete
Intensity
Ref. Level
B-3 Pre-Printed
This function can be used to set the paper length and gap size before you auto-calibrate the
sensor sensitivity. It is used to set the sensor sensitivity accurately.
Bline Mode
Manual
> Pre-Printed
Exit
When you select the [Pre-Printed] option, you will see the following message. Please
complete these steps：
3. Open the print head mechanism, put
the black mark under the media
sensor. Press the
to set the value into the printer.
x
xxx
4. Then, put the label without black mark
under the media sensor. Press the
the printer.
x
xxx
and
5. The bline sensor calibration is
complete. Press the
button the LCD screen will return to
the previous menu.
x
xxx
3/4
39
button
Media sensor
Black mark
button to set the value into
Media sensor
Label without
black mark
to reach the