Wasp WPL608 User Manual page 63

adjustment.
1. Decrease the right side print head pressure
adjustment knob setting 1 level per each
adjustment then print the label again to check if
wrinkle is gone.
2. If the right side print head adjustment knob
setting has been set to index 1 (the lowest
pressure index), please increase the left side
print head pressure.
3. If the left side print head adjustment knob
setting has been set to 5 (the highest pressure
index) the wrinkle can't be avoid, please rotate
the both knobs back to setting 1 then rotate the
Z-axis mechanism adjustment knob clockwise
for a few degrees and print again for fine tune
the print head pressure distribution.
Note for step 3:
*Factory default setting - the Z-axis knob is
rotated counter clockwise to the end of thread.
*Turn the Z-axis mechanism adjustment knob
clockwise until you feel the knob touch the
mechanism for the first adjustment.
* If the wrinkle is still there, please turn the Z-axis
mechanism adjustment knob clockwise about
1/4 circle each time for adjustment
* If the winkled direction is change from "ˊ" to "
ˋ" by adjusting the Z-axis mechanism
adjustment knob, please turn the Z axis
mechanism adjustment knob counter clockwise
to avoid the wrinkle.
adjustment.
1. Decrease the left side print head pressure
adjustment knob setting 1 level per each
adjustment then print the label again to check if
wrinkle is gone.
2. If the left side print head adjustment knob level
has been set to index 1 (the lowest index),
please increase the right side print head
pressure.
Z axis mechanism
adjustment knob
60