KEB C6 COMPACT 3 Instructions For Use Manual page 26

5 | Assembly
5 Assembly
5.1 Assembly instructions
26
To prevent damage to the product, observe the following instructions:
• Make sure that no components are bent and/or isolation distances are changed.
• The product must not be put into operation in case of mechanical defects. Non-compli-
ance with the applicable standards.
• Do not allow moisture, mist or toxic gas to penetrate the product.
• Avoid dust permeating the device. Allow for sufficient heat dissipation if installed in a
dust-proof housing.
• Observe minimum installation distances to surrounding elements.
• Do not cover the ventilation openings.
• Install the product in accordance with the required degree of protection (e.g. control
cabinet).
• Make sure that no small parts fall into the product during assembly and wiring (drilling
chips, screws etc.). This also applies to mechanical components, which can lose small
parts during operation.
• Secure the connection cable against mechanical influences (tension, vibrations).
KEB Automation KG
ma_ca_c6-compact3-inst-20372037_en