2.10 Front Panel Lockout
With front panel lock in effect the ability to change test conditions is prohibited. Only the
START and STOP buttons and the setup recall function (RCL) are functional.
To activate the front panel lockout:
•
With the instrument in standby status (Stop button previously pressed and no lights
blinking) enter [5] [0] [0] [0] and [OFF] from the data entry keys. The LOCK indicator
light will illuminate indicating the instrument is in the lockout state.
To deactivate the front panel lockout:
•
With the instrument in standby status (Stop button previously pressed and no lights
blinking) enter [5] [0] [0] [0] and [OFF] from the data entry keys. The LOCK indicator
light will go out indicating the instrument is no longer in the lockout state.
2.11 Software Version Display
The version of software, installed in the instrument, can be displayed on the front panel.
To display software version:
•
Press the front panel POWER switch to ON and immediately press the ENTER key. The
year will be shown in the left display and the month and day in the right display as
illustrated below. This software version display is only held for a couple of seconds.
2.12 Clear Setup Memory
All stored test conditions in instrument memory (50 setups) can be cleared with a few key
strokes.
To clear setup memory:
•
With the instrument in standby status (Stop button previously pressed and no lights
blinking) press CLEAR and then [5] [0] [0] [0] and CLEAR again.
Operation 2-18
www.valuetronics.com
V
HI
1997
DC
KV
LO
AC
A
ARC
m
02 15
uA
mA
M
G
Need help?
Do you have a question about the Guardian 5000 and is the answer not in the manual?