Omtech SH-G1610 User Manual page 69

4.7.21 Resetting Axes
When the green block is on this item, press ENTER, and the following dialogue box will pop up:
Push the ▲ and ▼ keys to move the light blue block to the intended item. Press ENTER to start the
resetting of the selected axis. The message "resetting is underway" will show on the screen. Upon
resetting, the message will automatically disappear and the system will return to the main interface.
4.7.22 Alarm Displays
During the operation of the system or the running of the machine, some alarm information may pop
up if there is a water protection error etc. For example, the water protection alarm may pop up as
shown below:
Correct the problem displayed and then select either "Enter" or "Esc" to exit.
62