Omtech SH-G1610 User Manual page 47

4.2 Pre-Operation Preparation
4.2.1 Turning on the Machine
1. Turn on your water cooling system.
2. (Optional) Turn on your additional ventilation system (such as a dedicated purifier).
3. Turn on the control panel by flipping the
main power switch on the back of the
machine to its ON position.
4. On the control panel, slightly rotate the
emergency stop button clockwise until it
pops up.
5. On the control panel, turn on the laser by
inserting and rotating the laser key.
6. On the control panel, press the Reset button.
7. Make sure the ammeter knob is turned
completely clockwise to its maximum setting.
8. Open the engraver's cover to check that the air assist is working properly. Close the cover.
9. Wait until the engraver is in standby mode and ready to use.
5
40
4
6