Omtech SH-G1610 User Manual page 51

4.4 Wrapping-up
1. Once you have finished engraving, close your software and then turn off your machine in the
following order:
a. Close your engraving software, and
unplug the USB cable or ethernet cable.
b. Turn and remove your laser key.
c. Press the emergency stop button.
d. Allow time for the ventilation and cooling
systems to continue running, cooling the
laser and removing any remaining fumes
or dust.
e. Turn off the control system power by
flipping the main power switch on the back
of the machine to its OFF position.
f. Turn off the water cooling system and your additional ventilation system if any (such as a
dedicated purifier).
2. Fully clean the workbed and check if the lens or any mirrors require cleaning. Use the bottom
access door to remove, empty, clean, and replace the debris tray. Store everything neatly away.
3. For best results, lock the bottom access door and disconnect your laser engraver from its power
supply between uses.
4.5 Rotary Operation (Optional)
4.5.1 Installing a Rotary Attachment
1. (Optional) If the engraved object is too
big, remove the honeycomb or remove the
honeycomb and the aluminum knife bed for
space.
c
b
44
e