Johnson Controls FireClass FC501 Series User Manual page 23

• Event localisation:
- Control panel or repeater
- Loop number
- Device type
- Device address
- Zone number
• Event cause
• Event time and date
Table 23: Keys function on the view event log
screen
Key Function
1 Views alarm events only
2 Views delay-to-alarm events only
3 Views warning events only
4 Views walk test events only
5 Views fault events only
6 Views restore events only
7 Views generic events only
Up Views previous event
Down Views next event
Right View next event information block.
See Figure
Left Views previous event information
block. See
Esc Cancels the operation and returns to
the previous screen
25.
Figure 25.
Figure 25: Scrolling of event log screens
Callout Description
1 Press the Right key to view the event
location.
Note: If an event is related to a
loop device, the event point label
is swapped with the point's zone
label every three seconds. If you
have not assigned the point to
a zone, only the point label dis-
plays.
2 Press the Right key to view the event
cause.
9 Key – View the firmware version
To view the control panel's firmware version, press
the 9 key on the ANALYZE menu. See
Figure 26: Viewing the firmware versions
To return to the ANALYZE menu, press Esc.
0 Key – View panel information
To view the panel information, press the 0 key on
the Analyze menu. The display shows the following
information:
• Control panel ID
• Control panel serial number
• Printed circuit board (PCB) version
• Type of power supply onboard
• Type of batteries onboard
• Presence of the auxiliary controller
FC501 Addressable Fire Control Panels User Manual
Figure 26.
23