Separating The Lcd Assembly From The System Cover - NEC VERSA S Service Manual

Separating the LCD Assembly from the System Cover

Follow these steps to remove the LCD assembly.
1. Turn off system power.
Unplug the Versa S and any peripheral devices connected to it.
2.
Remove the following items using the procedures provided earlier in this section:
3.
n
keyboard
n
hard disk
n
system cover and LCD assembly
n
LED circuit board
n
LCD cover.
4. Locate the two cover hinges at the bottom of the system cover.
5. Remove the two screws securing the two cover hinges.
6. Locate the two hinge plates at the top of the system cover.
Remove the four screws securing the two hinge plates. Remove the hinge plates
7.
and cover hinges.
Separate the LCD assembly and system cover.
8.
Figure Section 5-9 Separating the LCD Assembly and System Cover
Cover Hinge
Screw
(1 of 2)
Troubleshooting and Repair
Hinge
Plates
5-21