3.
Lower the keyboard back into position.
4.
Re-insert the plastic retainer as follows:
n
Locate the tabs on the retainer.
n
Align the tabs with the grooves in the system.
n
Fit the tabs into the grooves. The retainer will curve up slightly in the middle.
n
Once the tabs are fitted into the grooves, press down on the center of the re-
tainer until it snaps into place.
5.
Reconnect any external options that were disconnected before starting the instal-
lation.
To complete the software part of the installation, continue with the next section,
6.
"Running Setup."
Running Setup
The first time starting the Versa S after installing the memory module or hard disk, an error
message appears. Proceed as follows.
Memory Modules
If upgrading memory, follow these steps.
Press
1.
Ctrl-Alt-S
the new RAM size.
CAUTION: Be sure to tuck the keyboard cables
under the keyboard.
Tabs
Retainer
Figure Section 4-12 Inserting the Retainer
or
to start the SCU. The Versa S automatically looks at
Fn-F9
Options
4-15