6.
Slide the shield to the right away from the system board. Lift the shield out of the
system.
7.
Disconnect the hard disk from its connectors and slide it out of the system.
Removing the System Cover and LCD Assembly
Follow these steps to remove the system cover and LCD assembly from the system chassis.
1.
Turn off system power.
2.
Unplug the Versa S and any peripheral devices connected to it.
3.
Remove the following items using the procedures provided earlier in this section:
n
keyboard
n
hard disk.
4.
Close the LCD panel.
5.
At the rear of the system, open the port cover and remove the rear cover screw
securing the system cover to the system chassis.
Figure Section 5-13 Removing System Cover Screw (Rear)
Figure Section 5-12 Removing the Hard Disk
Screw
Troubleshooting and Repair
Hard Disk
Port Cover
5-15