Table of Contents
Advertisement
2-10
Setup and Operation
n
The next three blocks show system settings.
The Memory block displays system memory information.
The Peripherals block shows settings for system peripherals.
The Drives block specifies the diskette drive and hard disk installed.
n
The bottom line of the screen shows what key functions are available at that
screen level and what they do.
Using the SCU
Use the following procedure to use the SCU.
1.
Use the cursor arrows to highlight the menu selection and press
give three ways to make selections, depending on the option:
n
Enter information, as when setting the date or time.
n
Toggle between enabled and disabled, as when selecting Num Lock. Press
to enable a highlighted option. A check appears next to the enabled option.
ter
Press
Enter
disappears.
n
Some options display a list from which to choose as when selecting a ty-
pematic rate. Use the up and down arrows to highlight the selection and press
.
Enter
2.
Press
to return to the previous menu.
Esc
3.
Press
to save the SCU changes at any time while using the SCU.
F10
SCU Menu Options
Descriptions of menu bar selections and options follow.
Standard
Use the options under Standard to view and modify the following settings.
n
Date — Set the date using the format MM/DD/YYYY. The initial setup date is
01/01/1993.
n
Time — Set the time using the format HH:MM:SS. The initial setup time is
00:00:00.
to disable an enabled option. The option is disabled and the check
. Suboptions
Enter
En-
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
