Removing The Screw; Removing The Hard Disk - NEC VERSA S Service Manual

3. Locate and remove the screw that secures the protective shield and the drive.
CAUTION: Do not use a magnetic screwdriver
when removing the screw. Doing so can erase
the data on the hard disk.
Figure Section 4-8 Removing the Screw
Lift the shield out of the system.
4.
Disconnect the hard disk from its connectors and slide it out of the system.
5.
Figure Section 4-9 Removing the Hard Disk
6. Lower the new drive into the system, align the drive connectors with those in the
system, and slide the drive into position.
Options
Shield
Screw
Hard Disk
4-13