Default Setup; Exit; Apm Program - NEC VERSA S Service Manual

3-6 Power Management
6 Min
8 Min
12 Min
16 Min
Always On

Default Setup

Highlight Default Setup and press
fault settings.

Exit

Highlight Exit to exit the Power Management Utility screen.
n
Press Enter
Do you wish to save your changes?
ESC to exit – ENTER to save and exit
Any other key to continue
n
If no changes were made, the system displays the following message.
ESC to exit now
Any other key to continue
Follow the appropriate instructions.

APM PROGRAM

Advanced Power Management conserves power through features that are specified by the
APM program. APM settings are already specified in the system. When power management
is enabled through the SCU, the system retrieves the settings specified in APM and initiates
them after the defined timeouts. If the settings are changed, either through DOS or Win-
dows, the new settings are initiated. (See the MS-DOS and Windows User's Guide for de-
tails.)
The following subsections describe the APM features.
Enter to reset Power Management options to their de-
. If changes were made, the system displays the following message.