Removing The Lcd Cover - NEC VERSA S Service Manual

5-20 Troubleshooting and Repair

Removing the LCD Cover

Follow these steps to remove the LCD cover.
1. Turn off system power.
Unplug the Versa S and any peripheral devices connected to it.
2.
Remove the following items using the procedures provided earlier in this section:
3.
n
keyboard
n
hard disk
n
system cover and LCD assembly.
Locate the two rubber plugs that conceal the LCD cover screws.
4.
Using a small flat-tip screwdriver or other sharp object, remove the rubber plugs.
5.
6. Remove the two screws securing the LCD cover to the LCD assembly.
7. Locate the two LCD cover tabs that conceal the LCD cover screws.
Remove the two screws securing the LCD cover to the LCD assembly.
8.
Screws
Figure Section 5-8 Removing LCD Cover Screws
9. Remove the LCD cover from the LCD assembly as follows:
n
Grasp the two LCD cover tabs that concealed the screws removed in step 8.
n
Carefully lift up and remove the LCD cover.
Plug (1 of 2)
LCD Cover
Tabs
CAUTION: The LCD cover is fragile. Proceed
with caution when removing the LCD.
Screw (1 of 2)