NEC VERSA S Service Manual page 35

n
COM Port A — Set the Serial Port I/O Address for COM Port A.
COM1 (3F8h) – default setting
COM2 (2F8h)
COM3 (3E8h)
COM4 (2E8h)
Disable
n
SurePoint — Enables or disables the SurePoint pointer.
Enable – default setting
Disable
n
LPT Port Address — Set the parallel port I/O address.
LPT1 (378h) – default setting
LPT2 (278h)
LPT3 (3BCh)
Disable
n
Diskette Drive — Set the diskette drive type for Drive A. It is recommended that
this setting not be changed.
1.44 MB – default setting
720 KB
None
n
Hard Disk — Set the hard disk type for Drive C. If replacing the hard disk, see
the documentation that comes with the new drive for hard disk setting informa-
tion.
Standard
Custom
Auto – default setting
None
Setup and Operation 2-11