Lcd Panel Assembly; Bridge Battery, Cmos Battery, Cpu Assembly And Speaker Assembly - NEC SX Service And Reference Manual

LCD Panel Assembly

1. Remove six screws (
2. Disconnect the LCD panel cable at P3 on the main board.
3. Lift the LCD panel from the bottom cover assembly.

Bridge Battery, CMOS Battery, CPU Assembly and Speaker Assembly

1. Disconnect the CMOS battery cable from P13 on the main board.
2. The CMOS battery (
Gently pry up to remove.
3. Disconnect the Speaker assembly cable from P23 (
4. Lift the left and right speaker from the bottom assembly being careful not to
stretch the cable.
5. Disconnect the Bridge battery cable from P11 (
6. The Bridge battery (
to remove.
3-10 Disassembly and Reassembly
) on the back as shown in the following figure.
A
Back of system
A – Screws
) is held in place by a double-sided pressure tape.
C
) is held in place by a double-sided tape gently pry up
E
).
A
) on the main board.
D