External Devices; Parallel Devices; Modem And Telephone Connection; Connecting A Parallel Device - NEC VERSA S Service Manual

Figure Section 4-5 Modem and Telephone Connection

EXTERNAL DEVICES

This section provides installation procedures for connecting external devices to the Versa S.
Before connecting the device, set it up using the instructions that come with the device.

Parallel Devices

To install a printer or other parallel device, a cable with a 25-pin male connector is required.
For most parallel printers, one end of the cable should have a 36-pin Centronics
Follow these steps to attach a parallel device to the Versa S.
1. Open the port cover on the back of the Versa S and locate the parallel port.
2. Connect the 25-pin cable connector to the parallel port.
Secure the connection with the screws provided.
3.
Connect the 36-pin connector to the port on the device. Lock the connector clips.
4.
5. Connect the power cable to the printer and a properly grounded wall outlet.
Figure Section 4-6 Connecting a Parallel Device
Dual RJ11
Connector
Connector
Clips
Options
Screws
4-5
®
connector.