Monitor; Connecting The Mouse - NEC VERSA S Service Manual

4-8 Options
3. Connect the mouse cable connector to the port.
Turn on the system and start the SCU.
4.
5. Under the Standard menu, locate the SurePoint option and disable it.
Save the changes when exiting the SCU. The system automatically recognizes the
6.
external mouse.

Monitor

Before attaching the external monitor, change the VGA setting through the SCU or the
F2 function key. To use the monitor, the VGA option should be either CRT or Both.
If the setting is LCD, the Versa S does not recognize or activate the external monitor. See
Chapter 2 for details about using the SCU.
Follow these steps to connect an external monitor to the Versa S.
1. Turn off the power to both the external monitor and the Versa S. Do not leave the
notebook in Suspend mode. The system will not recognize the newly connected
monitor when returning to the operating mode.
Keyboard/
Mouse Port
Figure Section 4-9 Connecting the Mouse
NOTE: The SurePoint or its selection buttons
cannot be used when attaching an external
mouse.
NOTE: Use Fn-F2 to toggle between LCD,
CRT, and Both.
Mouse
Connector
Fn-