Serial Devices; Keyboard; Attaching A Serial Device - NEC VERSA S Service Manual

4-6 Options

Serial Devices

To install a serial device, like a printer or an external modem, a cable with a 9-pin female
connector for the system is required. Follow these steps to attach a serial device to the
Versa S.
1. Check that power to both Versa S and device is off.
Open the port cover on the back of the system and locate the serial port.
2.
Connect the device cable connector to the serial port. Secure the connection with
3.
the screws provided.
Align and connect the 9-pin connector to the correct port on the serial device. Se-
4.
cure the connection with the screws provided.
5. Connect the power cable to the serial device and a properly grounded wall outlet.

Keyboard

Follow these steps to connect an external keyboard to the system.
1. Turn off the Versa S. Do not leave it in Suspend or Standby mode.
Open the cover on the back of the Versa S and locate the external keyboard port.
2.
Figure Section 4-7 Attaching a Serial Device
CAUTION: Make sure the system power is off
whenever attaching or removing the keyboard.
Failure to do so can damage the keyboard.
Serial
Port
Screws