Lcd And Top Cover; Removing The Lcd Assembly (Step 1) - NEC Versa 2600 Series Service Manual

SOLD BY laptopia2005 DO NOT RESELL!!

LCD and Top Cover

Remove the LCD and top cover as follows.
Remove the front plates as follows.
1.
T
Remove the two front plates from the hand rest area on the laptop. It is rec-
ommended that you wear a rubber finger tip for gripping ease and slide the
plates from the laptop.
NOTE
During reassembly there is a left and a
right front plate.
Remove two screws from each bay.
¦
NOTE
During reassembly the screw under the
left plate are (2.5 x 6) and (2.5 x 3.5) under the
right plate.
Figure 4-8 Removing the LCD Assembly (Step 1)
2. Remove two each Left and Right Hinge covers by inserting a ceramic tip screw
driver or fingernail in the notch on the rear of the each of the hinge covers.
SOLD BY laptopia2005 DO NOT RESELL!!
Field Service Guidelines 4-11